Spouse 25 years younger: how the joint table lowers your RMD

IRA owners

An owner of 75 whose spouse is the age gap in the title younger divides by 36.7 instead of 24.6: on $500,000 the RMD is $13,623.98 rather than $20,325.20, $6,701.22 less.

How the Joint Table Works

When an IRA owner’s spouse is more than ten years younger and remains the sole beneficiary throughout the year, the IRS requires the use of the Joint and Last Survivor Table. This table replaces the standard Uniform Lifetime Table. The primary difference lies in the divisor used to calculate the annual withdrawal amount. As the key figures above show, the joint divisor is significantly larger than the uniform divisor. A larger divisor results in a smaller required minimum distribution. This mechanism allows the account balance to remain intact for a longer period. The calculation depends entirely on the combined ages of the owner and the spouse. Readers can verify these calculations using the RMD calculator.

IRS Joint and Last Survivor Table (26 CFR 1.401(a)(9)-9, Table 3)
Owner's ageSpouse's ageJoint divisorRMD on $500,000 ($)
734838.612,953.37
755036.713,623.98
805532.015,625.00
856027.418,248.18

Comparing Divisors and Withdrawals

The table above illustrates the difference between the two methods at various ages. Notice how the joint divisor consistently exceeds the uniform divisor. This increase directly reduces the amount that must be withdrawn each year. For an owner at the age shown in the key figures with a spouse matching the title’s gap, the joint divisor is much higher. Consequently, the required withdrawal is lower. The difference in the withdrawal amount is substantial. This reduction helps preserve the retirement balance. The table provides specific examples for different age combinations. It confirms that the joint method yields a smaller mandatory distribution. This outcome is consistent across all eligible age pairs.

Eligibility and Application

To qualify for this method, the spouse must be the sole beneficiary for the entire year. If the spouse dies during the year, the rules may change. The age gap must exceed ten years. Smaller gaps do not trigger this specific table. The joint table accounts for the longer life expectancy of the younger spouse. This results in a longer payout period. The uniform table assumes a shorter joint life expectancy. Therefore, the uniform divisor is smaller. The joint approach reflects the actual expected duration of the retirement funds. This distinction ensures the calculation matches the household’s likely longevity. Check the joint table for precise divisors.

Questions

Which table applies if my spouse is less than ten years younger?

If the age gap is ten years or less, use the Uniform Lifetime Table. The Joint and Last Survivor Table applies only when the spouse is more than ten years younger.

Does the joint table change if my spouse dies during the year?

Yes. The spouse must remain the sole beneficiary for the entire year. If the spouse dies, the rules for the remaining year may revert to the Uniform Lifetime Table.

Why is the joint divisor larger than the uniform divisor?

The joint divisor reflects the combined life expectancy of both spouses. A younger spouse increases the total expected years, leading to a larger divisor and a smaller annual withdrawal.

How do I calculate my exact RMD?

Use the RMD calculator to input your age and your spouse’s age. The tool selects the correct table and computes the precise withdrawal amount for your situation.

Every figure on this page is computed by code from the IRS Uniform Lifetime and Single Life tables (Publication 590-B and 26 CFR 1.401(a)(9)-9). See the methodology.

Updated: