Spouse 12 years younger: how the joint table lowers your RMD
IRA owners
An owner of 75 whose spouse is the age gap in the title younger divides by 26.1 instead of 24.6: on $500,000 the RMD is $19,157.09 rather than $20,325.20, $1,168.11 less.
- 26.1joint divisor at 75
- $19,157.09RMD with the joint table
- $1,168.11less than the Uniform table
Using the joint table
An IRA owner uses the joint and last survivor table when the spouse is the sole beneficiary for the entire year and is more than ten years younger. This choice replaces the standard Uniform Lifetime Table. The joint table provides a larger divisor, which directly reduces the calculated distribution amount. The key figures above show this reduction at the owner's age shown. The difference in the divisor drives the lower payment. Readers should verify their specific age gap qualifies for this method before calculating their obligation.
| Owner's age | Spouse's age | Joint divisor | RMD on $500,000 ($) |
|---|---|---|---|
| 73 | 61 | 27.9 | 17,921.15 |
| 75 | 63 | 26.1 | 19,157.09 |
| 80 | 68 | 21.6 | 23,148.15 |
| 85 | 73 | 17.4 | 28,735.63 |
Comparing the divisors
The table above lists divisors for several owner ages paired with spouses more than a decade younger. At the owner's age shown in the key figures, the joint divisor exceeds the Uniform Lifetime divisor. A larger divisor means the balance is divided into more parts, resulting in a smaller annual payment. The table above illustrates how this gap persists across different ages. The spouse's age determines the specific joint divisor used. Each row demonstrates the relationship between the two ages and the resulting factor.
Calculating the reduction
Applying the joint divisor to a fixed balance yields a lower required minimum distribution than the standard table. The key figures above highlight the specific dollar difference for the balance shown. This reduction occurs solely because the joint divisor is larger. The table above confirms that this pattern holds for the ages shown. The calculation remains straightforward: divide the prior year-end balance by the applicable divisor. No other factors change the result when using the joint method.
Timing and eligibility
Eligibility requires the spouse to be the sole beneficiary throughout the entire year. If the spouse is not the sole beneficiary for any part of the year, the standard table applies. The first distribution is due by the first of April of the following year. Subsequent payments are due by the end of each year. The joint table applies only when the age gap exceeds ten years. Confirm the spouse's status and age gap before relying on the lower divisor.
Questions
What qualifies for the joint table?
The spouse must be the sole beneficiary for the entire year and be more than ten years younger than the owner. If either condition fails, the standard table applies.
Does the joint table always lower the RMD?
Yes, when eligible. The joint divisor is larger than the standard divisor, which results in a smaller required distribution for the same balance.
When is the first RMD due?
The first distribution is due by the first of April of the year following the year the owner reaches the RMD age. Later distributions are due by the end of each year.
Every figure on this page is computed by code from the IRS Uniform Lifetime and Single Life tables (Publication 590-B and 26 CFR 1.401(a)(9)-9). See the methodology.